Fireplaces today come in a variety of sizes, styles, designs, and materials. Here are a few fireplace design from () that are available for you to choose from.
The Traditional Brick Fireplace Design : This type of fireplace can serve many different purposes, such as preparing food, providing heat to the home, and was often the place where the entire family would gather not only to keep warm but also to listen to each others stories of their daily happenings.
Bedford Fireplace Mantel's Design : This fireplace is the favorite choice for many cheap cinderella broadway tickets new homeowner of today. These Victorian style wood mantels would truly enhance any home and they often come with very large corbels to support the mantel shelf. Their block foot is what gives them their Victorian feel.
Colonial FireplacesDesign: These colonial fireplaces were replaced because of the amount of wood that they used for heating and cooking. Also in those days fireplaces were built as part of the house and used quite a lot of materials. If you had to do any repairs to these types of fireplaces that would entail the whole structure having to be broken down and rebuilt.
Compact Electric Fireplaces Design: This fireplace is by far the most modern and economical fireplace, not to mention that they are also the easiest to start and maintain.
Here are some basic instructions on how to install your new fireplace.
Wipe the surfaces of the fireplace clean to remove any dust build up. Hook up your burner and place it in the center of the fireplace, then do a check to ensure that you have the flame pattern in the center and make sure that it is moving upward and not flapping on the wall.
Go ahead and turn on the gas to do this test. Once you have found the location of the burner pour some crushed lava rock and keep it to about three to four inches away from the front of the fireplace.
Do not let the sand or lava show through the front of the burner. Now pull the burner to the top and do another test to make sure that the pattern has not changed.
Next cover the burner and lava rock with sand, and remove any spilled sand then relight it again, to check that the flame pattern is still the same.
Starting from the front and moving up to the back, pour the glass on the lava rock and sand base.
When you have finished pouring the glass you should make sure that the automatic starter is resting just above the glass so that it will work properly.